Interface of the HQ router from accessing the Branch server. Design a named access list BranchServer to prevent any computers attached to the Gigabit Ethernet 0/ R1 (config) interface gigabitEthernet 0/0 R1 (config-if) ip access-group 100 in. Enter interface configuration mode and apply the ACL. From R1 ’s perspective, the traffic that ACL 100 applies to is inbound from the network connected to Gigabit Ethernet 0/0 interface. Configure theĪccess list on the appropriate router, apply it to the appropriate interface and in the appropriate direction.į. Step 2: Apply the ACL on the correct interface to filter traffic. Interface of the Branch router from accessing HQServer. 8.3.1. Design a named access list HQServer to prevent any computers attached to the Gigabit Ethernet 0/ Set a default route on HQ which directs traffic to S0/0/1 interface. Configure Branch with appropriate addressingĭ.Document the addressing in the Addressing Table.Assign the last usable address of the first subnet to the Gigabit Ethernet 0/1 interface.Assign the last usable address of the second subnet to the Gigabit Ethernet 0/0 interface.
Divide 172.16.128/19 into two equal subnets for use on Branch. 10 10 0:00 / 26:39 8.3.1.2 Packet Tracer - Skills Integration Challenge Rachid Belouche (BR Learning) 157 subscribers Subscribe 3 Share 986 views 6 years ago cisco packet tracer CCNA. In this challenge activity, you will finish the addressing scheme, configure routing, and implement named accessĪ.
0 kommentar(er)
